Cybrotech GSM-1 Manual de usuario descargar pdf (Pagina 5)

After transfer is complete, module will reset automatically. Minute or two later, it will connect to network, and

both GSM and GPRS LEDs will be green. If configuration file has errors, GSM LED will blink.

Send SMS "cybro_qx02=1" to GSM-1.

In a few seconds, relay will turn on. Confirmation message (if configured) will be received soon.

- Open variable monitor.

- Call GSM-1 from your mobile phone.

- Variable gsm_incoming_call becomes 1, and gsm_incoming_rings increments on each ring. Calling number

will be displayed in array of variables incoming_number.

- Set gsm_outgoing_index to 0 and gsm_outgoing_call_req to 1 (will reset automatically). Your phone will ring.

- Make sure GSM module is configured to your WAN address (check http://www.whatismyip.com).

- Configure router to forward UDP port 8442 to your PC.

- Start CyBroPushServer, wait until push message appears.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

Cybrotech GSM-1 Manual de usuario Pagina 5