Cybrotech GSM-1 Manual de usuario descargar pdf (Pagina 7)

Example 2:

To send separate hi and lo messages, wire two inputs together:

Configuration word is 256 (iw0 hi limit) + 8192 (iw1 lo limit) = 8448.

send:

smsalarm=8448 iw0hi=850 iw1lo=5 sms0="Alarm: water high" sms1="Alarm: water low"

reply:

smsalarm=8448 ok iw0hi=850 ok iw1lo=5 ok sms0="Alarm: water high" ok sms1="Alarm: water low" ok

alarm: Alarm: water high

voicealarm - select inputs which will make a call

1 ix0 close 2 ix1 close 4 ix2 close 8 ix3 close

16 ix0 open 32 ix1 open 64 ix2 open 128 ix3 open

256 iw0 hi limit 512 iw1 hi limit 1024 iw2 hi limit 2048 iw3 hi limit

4096 iw0 lo limit 8192 iw1 lo limit 16384 iw2 lo limit 32768 iw3 lo limit

For a combined action, add values together. Limits and hysteresis are common with message alarm.

send:

voicealarm=15 rearm=300

reply:

voicealarm=15 ok rearm=300 ok

Any digital input (1+2+4+8) makes a call. Alarm is armed again after rearm period.

make a call

ix0

First call goes to first authorized phone number. To confirm a call, press "hang up" button. If not confirmed,

module will ring for about 30 seconds, then wait, then ring again. Call is repeated 3 times. Still not confirmed,

next call will advance to second authorized number, then third, until alarm is confirmed.

To use alarm call, you must authorize your phone. If no phone is authorized, module is not able to

make a call.

Authorization defines phones allowed to send commands. By default, access is allowed for everybody. Once

authorized, commands from other phones will be ignored. Authorized phone is recipient for alarm messages.

allow - add number to list of authorized numbers

send:

allow +385912345678

reply:

allow +385912345678 ok

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Cybrotech GSM-1 Manual de usuario Pagina 7